팝업레이어 알림

팝업레이어 알림이 없습니다.
ALL PRODUCTS  |  ORDER  

FAQs

You can become a coating expert if you refer to the FAQ board before coating on your vehicle.

 

FAQs LIST

  1. Q Why do we need to coat Top Coating on top of AQuartz PPF Base coating?

    A
    All painted surface has many micro-pores (pin-holes).
    As a newly painted surface cures, the micro-pores are created from the air trapped in the paint.
    And as time goes on, airborne chemical compounds, ferrous particles and dirt actually penetrate the paint,
    and gets stuck in the pin-holes within the paint surface.
    They create corrosive compounds that eat deep into the paint's sub-layers or paint's pin-holes.
    In order to keep the original car paint colour in perfect condition for long time,
    we have to cover the pin-hole and block UV rays with Aquartz Premium and Aquartz Titanium.

    So we have to remove all contaminants from the surface before AQuartz can be applied.
    Iron Cut or Clean Shot can be used to remove minor dirt easily.

    After thoroughly cleaning the entire painted surface,
    it must be covered up with AQuartz Premium Film before airborne chemical compound
    and the ferrous particles penetrate into the paint surface.
    But, Aquartz Premium is not sufficient enough coating to completely cover because it also has pin-holes.
    As AQuartz Premium forms the pin-holes from air pockets also,
    we require smaller nano-particles to cover the pin-hole of Aquartz Premium.

    That is why we need to use AQuartz Titanium.
    AQuartz Titanium covers the smaller pin-holes of AQuartz Premium.

    To obtain the best results,
    one layer is not sufficient to cover the pin-holes and block UV rays because it is too thin a layer.

    For thicker Aquartz Premium coating and Aquartz Titanium,
    you need to coat 2~3 layers of AQuartz Premium,
    and 1~2 layers of AQuartz Titanium coating as a final detailing step.

    The thicker Aquartz Premium and Aquartz Titanium coat will maintain your original car paint longer.

  2. Q Is PPF coating applied in the same way as the Titanium V3?

    A
    Yes, it's the same application

  3. Q Do I have to apply Base PPF Coating first before Top Coating?

    A
    Although it's not required, it's the best way to protect your car paint for a long term.

    PPF is a base layer for protect car paint from the outside damages
    like a film cover, and Titanium, T-Cera and Reload are a top layer for the
    effect of gloss, water-repellent, etc.

  4. Q The Curing Time of Base Coat or Top Coat

    A
    Regarding the curing time.
    - The basis of working temperature : 5~40 degrees Celsius (25℃ ).
    - The higher temperature and lower humidity make a shorter curing time.
    - The more it cures better protecting and water repellent it shows.
    - For short curing time(30 min~1 h), If you use a heat gun or sun-lights, you can save the curing time in 5 min ~10 min to coat 2 layers AQ on the first layer.
    - Completely cure with NO rain takes 24h.

    - After PPF applying, the interval of top coating is about 1 hour if you do not use a heat gun.
    - If you use a heat gun, after 20 min, you can apply top coating on the PPF layer.
    - Dry the layer of top coating like drying your hair.
Search QNA
게시물 검색