A
All painted surface has many micro-pores (pin-holes).
As a newly painted surface cures, the micro-pores are created from the air trapped in the paint.
And as time goes on, airborne chemical compounds, ferrous particles and dirt actually penetrate the paint,
and gets stuck in the pin-holes within the paint surface.
They create corrosive compounds that eat deep into the paint's sub-layers or paint's pin-holes.
In order to keep the original car paint colour in perfect condition for long time,
we have to cover the pin-hole and block UV rays with Aquartz Premium and Aquartz Titanium.
So we have to remove all contaminants from the surface before AQuartz can be applied.
Iron Cut or Clean Shot can be used to remove minor dirt easily.
After thoroughly cleaning the entire painted surface,
it must be covered up with AQuartz Premium Film before airborne chemical compound
and the ferrous particles penetrate into the paint surface.
But, Aquartz Premium is not sufficient enough coating to completely cover because it also has pin-holes.
As AQuartz Premium forms the pin-holes from air pockets also,
we require smaller nano-particles to cover the pin-hole of Aquartz Premium.
That is why we need to use AQuartz Titanium.
AQuartz Titanium covers the smaller pin-holes of AQuartz Premium.
To obtain the best results,
one layer is not sufficient to cover the pin-holes and block UV rays because it is too thin a layer.
For thicker Aquartz Premium coating and Aquartz Titanium,
you need to coat 2~3 layers of AQuartz Premium,
and 1~2 layers of AQuartz Titanium coating as a final detailing step.
The thicker Aquartz Premium and Aquartz Titanium coat will maintain your original car paint longer.
